REPAIR SOLUTION for Dead Panasonic GD35-75-92-93-95-96 :

solution for phone with BGA or no BGA chip

you need :

- 1 dead phone and 1 working phone
- hot air station and soldering station
- PC with cable
- software (WinMoDo with language pack)

Steps :

- connect good phone with cable to PC
- starting upload language
- when you see 20-30 % writing - disconnect cable from phone
- in display you see Writing and phone frezee
- phone in FLASHING MODE
- reboot PC
- desolder from bad phone flash chip
- desolder from good phone flash chip
- YOU NEED DESOLDERING FLASH CHIP FROM WORKED,
POWERED AND FREEZED in flash mode PHONE !!!!!!!!
CAREFULY !!!!!!!!!!!!!
- SOLDERING BAD CHIP in good phone (phone still avaible in flash mode)
- connect phone with cable to computer
- run program (for GD35 you need start Skeptik and full flashing), for another phone use Winmodo with option writing BOOT, MAIN and LP flash

ENJOY

P.S. tested and approved by m.com - GD35, 92, 93, 95

ATTENTION!!!
AUTHOR TAKES NO RESPONCIBILITY FOR DAMAGED PHONES!
ATTENTION!!!

my expirements - 6 bad flash chip - only way re-programming on LabTool-148C or LabTool-48 but I repaired over 50 phones.